It is a manufacturers warranted part, it is a straight forward replacement as long as you are careful, and it is working well. It is expensive when you purchase in the UK, I think you pay the Australian equivalent of VAT and also UK customs duty all based on the total cost including postage! If you want your machine to work then you have little alternative.
Verified purchase: Yes | Condition: New
The pump is probably fine in other machines or in other applications. For use with EM6910 I would reconsider and not replace the pump. There are many EM6910 users with well known steam issues. These pumps are likely not fit for purpose in this machine. My recommendation is dismantle and clean your own pump. Flush the thermoblock, clean the wand. If you have constant steam problems either give up (sadly), replace the pump with something else (not worth it) or even wilder ideas like routing the hot water across to the steam thermoblock (huge effort) and use the main pump. Either way, I have worked with my old pump and replaced with this new one with unreliable results ultimately. The pump is not up to the task in this machine (EM6910).
Verified purchase: Yes | Condition: New
Had my pump fitted in for 2 months now and it's working great. No leaks and out seems quieter than the earlier one.
Verified purchase: Yes | Condition: New
Saved a lot of time and money by ordering this part online and installing it myself. Not technically minded but the operation was pretty simple and straight forward.
Verified purchase: Yes | Condition: New
Easy to install, in fact if you clip the cable ties carefully you can swap it out without drilling the rivets out on the machine, as the rubber stretches enough to pull out the old and install the new. If you're doing it this way you may need an extra cable tie as I had to remove am extra one for leverage, but it comes with two cable ties regardless. It's a bit pricey for a cheap pump, but it does the job and it's cheaper than replacing the machine. I can't recommend Sunbeam coffee machines, as they're poorly made and hard to service, but this replacement part is perfect for the job of you already have one and want to get it going again after stream pump failure.
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Coffee, Tea & Espresso Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Coffee, Tea & Espresso Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
