Best value for money Floor Jack on eBay. Pumps up quick with it's dual pumping feature. Nice low profile so slides under vehicle easy. Simple to operate and castor wheels are really smooth running which is really good. Very strong construction as well. This Trolley Floor Jack is a must have for all workshops or home Mechanics. Highly recommend.
Verified purchase: Yes | Condition: New
Overall this is a good jack for the price. It does what they say, and its definitely a low profile jack that'll jack up a car. But, be warned, this jack won't get under most lowered cars. This jack just doesn't have the reach to get at the vehicle jacking points before you hit the higher parts of the jacks frame. I've tired this jack on several lowered vehicles, and each time I've needed to use ramps to get the vehicle up high enough to get this jack under it. If you want a cheap jack that gets your car off the ground, this one will sure do that. But if you want a jack that can get under lowered cars without needing to buy ramps to get the extra clearance height to reach the jacking points, you might want to buy a super low profile *long reach* jack instead.
Verified purchase: Yes | Condition: New
Good quality Lifter, competitively priced, delivered quicker than expected, is understandably a bit heavy to push around and has great lift height of over 600mm being one of the main reason I purchased this equipment.
Verified purchase: Yes | Condition: New
It was very stiff to operate at first and required a large amount of WD40 to penetrate all the moving parts to enable it to operate properly. The metal unpainted parts around the 2 pumps were covered in a white corrosion material. It looked to me that it had been stored for some time in an atmosphere with a lot of salt. ie. a warehouse near the sea or too long on a container ship. After quite a bit of work cleaning it up and loosening the "twist handle" it now appears to be working OK.
Verified purchase: Yes | Condition: New
For the price, cant complain. Good height, but dont be fooled. Lifting a lowered car is still a pain, the way the handle has to pump is still tricky. It can only lower down to about 75 degrees, instead of 90, so you still need a fair bit of room to swing the handle up and down. Can be a pain if you lift from a deep cross member. Construction... chineses MIG welders... what do you expect... I have some porous welds on the lifting arm pivot point, this is an important weld... Will need a bit of love from my welder :) I added a bit of grease here and there to eleminate noise from the jack while lifting heavy loads. Generally, you get what you pay for, so not too bad.
Verified purchase: Yes | Condition: New
It works as it should, is easy to manouver, and well priced. I guess you couldn’t ask for more!
Verified purchase: Yes | Condition: New
Easy to use and was able to lift the entire front end of my car with ease (2 door jeep jk).
Verified purchase: Yes | Condition: New
Impressed except for when the handle is upright it is almost vertical allowing it to fall back if bumped. Ground a little notch in handle housing where it stops against a bolt, allowing the handle to rest past vertical. Problem fixed.
Verified purchase: Yes | Condition: New
Works just as well as my kingchrome Jack just a little stiff unlocking the valve
Verified purchase: Yes | Condition: New
Does what it should. The only issue i had with the delivery where the person left it on the nature strip. Not the smarted thing to do
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Jacks & Jack Stands
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Jacks & Jack Stands
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
