This things awesome for how much you're paying. I had to strip some wires and solder a bit due to the cooler fan lead being insanely short. Don't know why it's so short, but I just used the cord from the original fan that came with my Anet A8 and bob's yer uncle. (Haven't soldered in 20+ years before this, so if I can do it so can you) Definitely recommend this if you're trying to save some money anywhere you can. I'm as happy as Larry. Also - I would suggest printing off a modular bracket for this thing. I used Anet A8 E3D V6 Bowden MODULAR X Carriage V4 from Thingiverse. It holds the stock sensors, which I had, the stock cooling fan AND allows room to clip the heatsink fan that comes with this thing. (NOTE: If you use the Spiral fan duct from Thingiverse with an Anet A8, it may NOT fit. I had to remove it and use the semi-circular one for now)Read full review
Verified purchase: Yes | Condition: New
Hot end is great, however cooling fan is on the small side. It was an easy print to pair it with a 40mm fan so not a big problem
Verified purchase: Yes | Condition: New
Fan failed after 10 hours, everything else ok
Verified purchase: Yes | Condition: New
Works even better than I expected. Have done over 20 hours of printing with it so far and no problems.
Verified purchase: Yes | Condition: New
Was good i adapted it to the cocoon create mini and it is working well
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in 3D Printer Parts
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on 3D Printer Parts