Item works as advertised. Nowhere in the documentation provided indicates the pool pressure to enable a correct decision on the type of item purchased. i.e. When the cyclonic brush is attached the unit moves extremely slow, even when on setting 3 (too much drag??), though it does clean residue left behind using the normal brush, which does it's work quickly, even on setting 2. A simple note about the minimum pool pump pressure requirement would be nice.
Verified purchase: Yes | Condition: New
Reasonable product, but has some basic design problems as it will get stuck on outer curves like the end of steps etc where the suction will hold it in one place and the treads cannot get traction as they are suspended on both sides, otherwise a good cleaner which picks up leaves very well. It is well constructed and easy to use.
Verified purchase: Yes | Condition: New
This little cleaner does an incredible job. Our pool is always in great condition. So easy to install and operate.
Verified purchase: Yes | Condition: New
all in all this is a good product... it covers the floor and walls too, it goes up to the water rim. just keep an eye for those pesky fallen sticks as they may jam in there and stop it from working, if that happens just remove the stuck stick and leaves that get jammed on top of the stick and you're running fine again.
Verified purchase: Yes | Condition: New
Zodiac MX8 has proved to be a great buy, really impressed with it as finally a machine that does everything as per description. Climbs wall right to the top, all over the floor and does not get stuck! A great unit
Verified purchase: Yes | Condition: New
I have had this cleaner for over a month and am quite happy with it, however, it doesnt climb the walls of my pool as well as the one in the demo videos. My suction was actually a little higher than recommended (10 revs/19sec), so this may be due to the shape of my pool. Being in an arid climate, i get a lot of dust, pollen, and grass etc blown into the pool so I have recently started running it with a Gator in-line surface skimmer. The two of them do a great job keeping both the top and bottom of my pool clean. I prefer the MX6 over the loud kreepy krawly type cleaner it replaced and i have recommended it to several of my friends. Pros - quiet, no fuss, Cons - extra hose lengths are expensive.
Verified purchase: Yes | Condition: New
Great little pool cleaner . Due to its design it goes through a series of cycles which stops it from getting stuck for any great length of time . It gets the pool spotlessly clean . The only negative occasionally it tries to crawl out of the pool sucking in air but it soon changes direction and purges itself . I’ve bought some duds in my time this one I highly recommend , Kerry .
Verified purchase: Yes | Condition: New
We have found the Zodiac MX8 MkII Pool Cleaner to be far superior than our old pool cleaner. Our old cleaner constantly got stuck in one corner of our rectangular fibreglass pool. We found the Zodiac MX8 MkII does not have this problem and cleans the entire pool without a hitch. We have also teamed it up with a Zodiac Leaf Catcher which we are also pleased with as we are surrounded by trees. It is far too early to tell if it will last the distance but so far it is looking promising.
Verified purchase: Yes | Condition: New
Exceeded my expectations. A great start with this product. Haven't needed to vacuum the pool for 3 weeks.
Verified purchase: Yes | Condition: New
I have had a Zodiac G3 for years and it worked ok but was always getting stuck on my steps. My MX6 is awesome it doesn't get stuck and my pool has never been cleaner. great product easy to set up and use
Verified purchase: Yes | Condition: New
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Pool Cleaners & Vacuums
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on Pool Cleaners & Vacuums